Add：No.#658 Binhai Road, Duqiao Town, Linhai City, Zhejiang,China
Phone:0086 137 5760 3958
0086 135 8615 6380
Tel:0086 576 85509707
Fax:0086 576 85509707
A multi-knife multi-stage stone cutting machine consist […]
A multi-knife multi-stage stone cutting machine consisting of cutting knife set, stone conveyor table, positioning guide plate and frame. The cutting knife set is on the upper part of the stone conveyor table and placed on the frame. The positioning guide plate is fixed between the cutting knife set. The cutting knife set is composed of motor, belt, cutter wheel shaft and cutting knife, and the cutting knife is fixed on the axle of the cutter wheel. This kind of stone cutting machine can cut stone in different depths, can process stone below 1 m3, can turn waste into treasure, greatly save stone resources, and is conducive to environmental protection. All kinds of stone can be machined. The processing efficiency is high, and the small stone can be effectively used, so that the production cost is low.
Composition and use
Stone cutting machine is composed of cutting knife set, stone conveyor platform, positioning guide plate and frame. Stone cutting machine is made of iron suitable for dry cutting, wet cutting of all kinds of stone, building materials, ceramic tile, granite, marble, cement board, red brick, refractory brick, etc. It is a necessary tool for home decoration.
Stone cutting machine can cut stones in different depths, can process stones less than 1 m3, can turn waste into treasure, greatly save stone resources, but also conducive to the protection of the environment.
I. Before Work
1. Put on your overalls and goggles. The long hair of the female worker coils up her hair and puts on her work cap.
2. The power switch, the tightness of the saw blade, the saw blade shield or the safety baffle should be inspected in detail. The operating table must be stable and sufficient lighting should be provided for night operation.
3. Turn on the main switch and try several turns without load until it is confirmed that it is safe to start.
1. It is strictly forbidden to wear gloves. If dust is caused during operation, wear a mask or face mask.
2. No attempt shall be made to cut small pieces of work that have not been clamped.
4. This cutting machine only permits cutting profiles.
5. No strong cutting operation is allowed. The motor should reach full speed before cutting.
6. No one is allowed to stand behind the saw.
7. Don't lean over or around the saw machine. When the saw blade is not stopped, don't release any hand or raise arm from the saw or workpiece.
8. Do not operate when the shield is not in place. Do not place your hand within 15 cm from the saw blade.
9. The power supply must be cut off before repairing or replacing the fittings, and the saw blade must be completely stopped.
10. If abnormal sounds are found, the examination should be stopped immediately.
III. After Work
1. Turn off the main power supply
2. Clean and tidy workbenches and sites
4. If personal or equipment accidents occur, the scene shall be maintained and the relevant departments shall be reported.